Trade solutions
McGuire-Nicholas gear by trade
Pick the work you do. Each aisle holds the belts, pouches, holders and pads its tasks call for, with the reason each piece is there.

11 pieces
McGuire-Nicholas Gear for Framing & Carpentry
A framer carries fasteners by the handful, a hammer and a square, all day. This aisle is built around that load. 11 pieces.
- Deep fastener pockets you can grab from without looking
- A hammer loop on the side you swing from
- Suspenders once the rig passes a few pounds
5 pieces
McGuire-Nicholas Gear for Electricians
Electrical work means many small tools: pliers, strippers, drivers, a tester and a roll of tape. These pieces give each one a slot. 5 pieces.
- Narrow slots for pliers and screwdrivers
- A chain or clip for electrical tape
- A leather pouch that stands up to sharp tool tips


7 pieces
McGuire-Nicholas Knee Pads for Flooring & Tile
Floor and tile installers spend most of the day on their knees on hard, finished surfaces. These pads cushion the knee and protect the floor. 7 pieces.
- A cap that won't mark the floor you just laid
- Gel that doesn't pack flat by noon
- Straps that stay put when you shuffle forward
4 pieces
McGuire-Nicholas Gear for Roofing, HVAC & Plumbing
Roofers kneel on a slope, HVAC techs crawl through attics, plumbers work under sinks. The pads here have wide caps that stay steady on uneven ground. 4 pieces.
- A wide, flat cap that doesn't roll on a pitch
- Padding that works all day on joists and decking
- Small tool storage that clips onto any belt


8 pieces
McGuire-Nicholas Gear for Garden, Garage & DIY
Not every job is a jobsite. Knee pads for weeding, a small tote for the kit under the sink, a hook for the drill on the garage wall. 8 pieces.
- Light pads you can pull on in a second
- A tote that carries a small kit
- Somewhere to hang tools off the floor